深圳市集电通实业有限公司

电话 : 0755-8830-8258

邮编 : 518129

邮箱 : andyzheng@jdtfuse.com

网址 : http://www.joincircuit.com/

Understanding the Rated Voltage of a Fuse

The rated voltage is the voltage at which an appliance operates normally. It is the optimum voltage for long-term operation: too high a voltage burns the appliance out, while too low a voltage causes abnormal operation (lamps that do not light properly, motors that do not run properly). At this point every component inside the appliance is working at its best, and only under these conditions does the appliance perform stably and achieve a long service life. (Related reading: Operating Principle of Resettable Fuses)
 
 
Whether a fuse opens depends on the magnitude of the current flowing through it, not on the operating voltage of the circuit. The rated voltage of a fuse is specified from the standpoint of safe use: it is the highest circuit voltage at which the fuse can be installed and still operate safely. This means a fuse may only be used in circuits whose operating voltage is equal to or lower than the fuse's rated voltage. Only then does the fuse work safely and effectively; otherwise, when it opens, sustained arcing or voltage breakdown may occur and damage the circuit.




 
Fuse
 
 
When the fuse material and its geometry have been determined, its resistance R is fixed as well (ignoring the temperature coefficient of resistance). As current flows through it, the element heats up, and the amount of heat generated grows with time. The current and the resistance set the rate at which heat is generated, while the construction of the fuse and the way it is mounted set the rate at which heat is dissipated. If heat is generated more slowly than it is dissipated, the fuse will not open. If the two rates are equal, the fuse will not open within any reasonable period either.
 
 
If heat is generated faster than it is dissipated, the accumulated heat keeps growing. Because the element has a finite specific heat and mass, this excess heat shows up as a rise in temperature, and once the temperature exceeds the melting point of the fuse element, the fuse opens. That is the operating principle of a fuse.
 
 
From this principle it follows that, when designing a fuse, you must carefully study the physical properties of the materials you select and ensure that their geometry is consistent, because these factors play a decisive role in whether the fuse works properly. Likewise, when using a fuse, always install it correctly. (Recommended reading: Is a Fuse the Same as a Circuit Breaker?)

上一条:已经是第一条了!

下一条:自恢复保险丝为什么用高分子材料制作?