深圳市集电通实业有限公司

电话 : 0755-8830-8258

邮编 : 518129

邮箱 : andyzheng@jdtfuse.com

网址 : http://www.joincircuit.com/

Points to Check When Buying a Resistor

Resistors keep coming up among colleagues in the fuse industry, so in the previous articles we covered what a resistor is and what it does. Today we will look at what to watch for when buying resistors and at the requirements for measuring them.
 
 
As with any product, there are points that deserve particular attention when a resistor is chosen. A resistor should be checked before it is used: the check is simply a measurement of the actual resistance against the nominal value, to confirm that the deviation stays within the permitted tolerance. The instrument for the job is the resistance range of a multimeter.
 
 
Next, two points to keep in mind when measuring a resistor (Related reading: what a resistor does)
 
 
1. Set the range from the resistance being measured, so that the pointer rests in the middle part of the scale, where it is easy to read.
 
 
2. Once the resistance range is selected, zero the meter: short the two probes together and turn the zero-adjust control until the pointer sits exactly on the “0” mark of the scale, then measure the resistor. Also keep your hands off the body of the resistor and the metal parts of the probes, otherwise the reading will be in error.
 
 
If the value measured with the multimeter is close to the nominal value, the part can be considered basically good; if it is far off, or there is no continuity at all, the part is faulty.
 
 
So the notes above should give you a reasonable picture. Do take care when selecting components: that is how you take responsibility for your product and for your own safety, and safety matters a great deal with electrical items. That is all for today; if anything is unclear, leave a comment and we can discuss it. (Recommended reading: How packaging affects the thermal performance of resettable fuses)