Overcurrent protection can be built into a circuit in many ways. The most common approaches are protection centered on an SCR, protection centered on a relay, protection centered on a transistor, temperature-controlled circuits using a bimetallic strip, dedicated IC protectors and one-time fuses.
Apart from the one-time fuse and the bimetallic strip, every one of these methods needs sampling, amplifier circuits, comparators, sensing elements, control and driver circuits and other supporting circuitry. They all share the same drawbacks: more components, more PCB area, more wiring, and greater difficulty in design, production and tuning, which pushes up cost. The failure rate of the appliance is therefore higher and servicing costs rise. (Related reading: Fuse or Fusible Resistor: Which Is Better?)
On the other hand, a design built on a bimetallic strip or a one-time fuse has a simple circuit and needs only one series component, but a one-time fuse protects the circuit only once and cannot be reused, while a bimetallic strip will keep reconnecting the faulty circuit if the fault is not cleared, extending the damage.
The comparison above shows that all of these methods have shortcomings and cannot protect a circuit well enough, which is why Shenzhen Joincircuit Industrial Co., Ltd. manufactures resettable fuses and the wider range of overcurrent protection devices. A resettable fuse is close to the ideal overcurrent protection component: only one is needed, connected in series, which cuts the component count and saves PCB area, and it can be reused in the circuit.
Resettable fuses made by Joincircuit consist of a polymer with conductive particles dispersed in it. After a special processing step, the conductive particles form chain-like conductive paths through the polymer. Under normal operating current the fuse is in a low-resistance state; when an abnormal overcurrent flows, the heat generated by the high current makes the polymer expand rapidly and breaks the conductive paths formed by the particles, so the fuse switches to a high-resistance state.
When the overcurrent disappears, the polymer cools and returns to its normal volume, the conductive particles reconnect into conductive paths, and the fuse returns to the low-resistance state. That is why these devices are also called resettable fuses, polymer PTCs or PPTCs. (Recommended reading: Which Brand of Resettable Fuse Is Best?)