深圳市集电通实业有限公司

电话 : 0755-8830-8258

邮编 : 518129

邮箱 : andyzheng@jdtfuse.com

网址 : http://www.joincircuit.com/

How a Resistor Works

In earlier articles we introduced the basic concept and construction of a resistor, but its working principle was still unclear. In this article we look in more detail at a related topic: how a resistor works.
 
 
A resistor is used in a circuit mainly to adjust and stabilize current and voltage. It can act as a current divider or as a voltage divider, and it can also serve as a matched load. As the circuit requires, it is further used for negative or positive feedback in amplifier circuits, for voltage-to-current conversion, and as a voltage or current protection element when the input is overloaded. Resistors can also be combined into RC circuits to serve as oscillating, filtering, bypassing, differentiating, integrating and time-constant elements.
 
 
A resistor consists of three parts: the resistive element, the substrate and the terminals (in a solid-core resistor the element and the substrate are one and the same). Only the resistive element determines the resistance value. For an element of uniform cross-section the resistance is R = rho L / A, where rho is the resistivity of the resistive material (ohm-cm), L is the length of the element (cm) and A is its cross-sectional area (cm2). (Related reading: Introduction to Resistors)
 
 
The thickness d of a thin-film element is very small and hard to measure accurately, and rho also varies with thickness, so the quantity is treated as a constant that depends on the film material and is called the film resistance. In practice it is the resistance of a square of the film, which is why it is also known as sheet resistance (ohm per square). For a uniform film the resistance is R = Rs L / W, where W is the width of the film (cm). Rs should normally be kept within a limited range, because if Rs is too large the stability of the resistor suffers. Cylindrical elements are therefore grooved, and planar elements are etched with a meander pattern, so as to widen the resistance range and to allow fine trimming of the value.
 
 
Parameters and characteristics. The main parameters that characterize a resistor are the nominal resistance and its tolerance, the rated power, the load characteristics and the temperature coefficient of resistance.
 
 
The nominal resistance is the design value marked on the resistor in figures or by a color code. The units are the ohm, the kilohm (kohm), the megohm (Mohm) and the teraohm (Tohm). Values are manufactured to standardized preferred number series, and the series used corresponds to the permitted tolerance.
 
 
A two-terminal electronic component made of resistive material, with a defined construction, that limits the current flowing in a circuit. A resistor whose resistance cannot be changed is a fixed resistor; one whose resistance can be varied is a potentiometer or variable resistor. An ideal resistor is linear, that is, the instantaneous current through it is proportional to the instantaneous voltage applied across it. (Recommended reading: Points to Note and Requirements When Choosing a Resistor)
 
 
That is the basic working principle of the resistor. For more information on resistors, please keep following the website of Shenzhen Joincircuit Industrial Co., Ltd., which is updated in real time with the information you are looking for. You are welcome to call us for samples, to ask our online sales staff about anything you do not understand, or to browse the Joincircuit technical support knowledge base. Thank you for reading.