Earlier we introduced the PPTC overview and its working principle. So is PTC the same as PPTC? And what is its operating principle? Below we analyse the operating principle of PTC.(Related reading: Factory-direct PPTC full range, 250 V rated leaded resettable fuse A250)
PTC is the acronym for Positive Temperature Coefficient, meaning a positive temperature coefficient; it generally refers to semiconductor materials or components with a positive temperature coefficient, whose resistance rises as ambient temperature rises. Its counterpart is NTC, the acronym for Negative Temperature Coefficient, meaning a negative temperature coefficient, generally referring to semiconductor materials or components whose resistance falls as ambient temperature rises.
There are many types of PTC thermistors. By material they can be divided into ceramic PTC (CPTC) and polymer PTC (PPTC). So PPTC is one type of PTC, and polymer PTC is also commonly called a resettable fuse.
A PTC thermistor is a typical temperature-sensitive resistive component: when its internal temperature exceeds a certain value (the Curie temperature), its resistance rises steeply with temperature. A typical R-T (resistance-temperature) curve is shown below:
Because this type of PTC changes instantly, it is often used for overcurrent protection in electrical appliances. From Joule's law, Q = I^2*R*t, we know that the heat generated in a conductor is proportional to the square of the current I flowing through it, so once the current increases, the heat Q rises sharply.
Under normal operation the operating current is relatively small, so the heat generated by the PTC current is not enough to reach the Curie point; the PTC therefore stays at its as-shipped zero-power resistance Rmin, usually a very small value (the exact figure depends on the PTC series), equivalent to a closed switch. When the current through the PTC reaches twice the normal operating current Ih, heat builds up inside the PTC until the Curie point is reached, and the PTC resistance immediately jumps to its maximum value Rmax, equivalent to an open switch. When the switch is truly open its resistance is ∞; typically the Rmax/Rmin ratio is at least greater than 10^4.
Once the internal heat has dissipated and cooled down, the resistance automatically returns to its initial value Rmin. That is why a PTC is often called a resettable fuse, a resettable overcurrent protector, and so on.