深圳市集电通实业有限公司

电话 : 0755-8830-8258

邮编 : 518129

邮箱 : andyzheng@jdtfuse.com

网址 : http://www.joincircuit.com/

Precautions for Installing a Resettable Fuse

In the fuse industry, resettable fuses are used quite widely, so every application area carries its own precautions that keep products safe and reliable. Today we walk you through the points to watch when installing a resettable fuse.
 
 
1. Avoid mechanical stress on the device body: Resettable fuses expand thermally because of the polymer itself during operation. If a particular mounting method puts pressure, squeezing, twisting or bending on both ends of the device body, that thermal expansion is restricted, which easily degrades the electrical performance of the resettable fuse and stops it from protecting the circuit under fault conditions.
 
 
2. Avoid chemical contamination of the device: certain greases, solvents, oils, fuels, industrial cleaning agents, outgassing from adhesives, silicone oils and electrolytes may impair device performance, and designers should take this into account.

 

                    
Leaded resettable fuse
 
3. Soldering precautions: when wave soldering or reflow soldering is required, follow the specified process.
 
 
a. When spot welding (resistance welding) is used to join the terminals of a polymer resettable fuse, the weld spots should be kept at least 2 mm from the edge of the device body so that the specified electrical performance is maintained, and solder spatter must never reach the resettable fuse body. The welding conditions must also not heat the PTC device above its maximum temperature. (Related reading: What resettable fuses can solve in security and surveillance equipment)
 
 
b. When hand soldering, avoid soldering temperatures high enough to heat the PTC device above its maximum operating temperature. Soldering time should also be controlled, and operators should work to a strict soldering process specification.
 
 
4. Avoid short circuits in uncoated devices: when an uncoated PTC device is used, conductive contamination such as metal chips or solder balls between the edge of the PTC device and its holder can lead to oxidation, burning and other failures.
 
 
5. Other precautions: operating beyond the maximum ratings of the device, or using it incorrectly, will damage the device and may cause arcing or burning. The device is intended for protection against occasional overcurrent or overtemperature faults and should not be used where faults recur continuously or persist for a long time; if the operating circuit contains large inductive components, an induced voltage may be generated across the resettable PTC device that exceeds its rated voltage. (Recommended reading: Resettable fuses in security applications and the characteristics of security equipment)
 
 
The above is our summary of the precautions for installing resettable fuses. If anything is still unclear, leave a message for us on the Contact Us page and we will give you a satisfactory answer as soon as possible.

上一条:已经是第一条了!

下一条:自恢复保险丝为什么用高分子材料制作?