深圳市集电通实业有限公司

电话 : 0755-8830-8258

邮编 : 518129

邮箱 : andyzheng@jdtfuse.com

网址 : http://www.joincircuit.com/

SMD Resettable Fuse: Parameters and Uses

SMD resettable fuses from Shenzhen Joincircuit Industrial Co., Ltd. are polymer SMD fuses developed in-house. They cover a wider range of applications than leaded resettable fuses, and under normal storage conditions the service life of a polymer resettable fuse can be regarded as unlimited. Today we take a brief look at the main applications of SMD resettable fuses.
 
 
When the electronic protection device market was still immature, overcurrent protection relied on conventional one-shot fuses. Such a device could be used only once and had to be replaced after a single overcurrent event before the downstream circuit could again be protected against excessive current.
 
 
After the resettable fuse was successfully developed there was indeed a short period of market scepticism, but repeated testing has shown that, stored correctly, a polymer resettable fuse has no finite service life. In excessively hot or humid environments some of its characteristics may be degraded. (Related reading: Resettable fuses as overcurrent protection in low-voltage power supply products)
 
 
The SMD resettable fuse (PPTC, polymer positive temperature coefficient) is a positive-temperature-coefficient polymer thermistor used for overcurrent protection in place of a current fuse. In normal operation its resistance is very low, so the voltage drop across it is very small. When an overcurrent raises its temperature, the resistance rises sharply by several orders of magnitude, dropping the circuit current below a safe level and protecting the downstream circuit; once the overcurrent clears, the device returns automatically to its low resistance. The effect is similar to a switching element, except that the response is slower.

SMD resettable fuse
 
 
Key parameters of SMD resettable fuses
 
 
1) Hold current IH: the maximum current at which the resistance does not change abruptly.
 
 
2) Trip current IT: the minimum current that makes the resistance rise abruptly; it is usually twice the hold current.
 
 
3) Trip time Ttrip: the maximum time to trip at 5IH (LP series), 3IH (LBR series) or the specified current (other series). The higher the current and/or the temperature, the shorter the trip time. (Related reading: Which brand of SMD fuse is best)
 
 
4) Maximum voltage Vmax: the maximum voltage the device can withstand at rated current; the maximum interrupt voltage Vmax interrupt is sometimes quoted instead.
 
 
5) Maximum current Imax: the maximum fault current the device can withstand at rated voltage.
 
 
6) Typical power dissipation Pdtyp: the power consumed in the tripped state.
 
 
7) Static resistance R: with no power applied the resistance should lie within the range set by the minimum static resistance Rmin and the maximum Rmax, that is, Rmin≤R≤Rmax. Note in particular that all of the above values apply at 25 °C in still air and change with temperature. Hold current IH, trip current IT and trip time Ttrip all fall as temperature rises and rise as temperature falls.
 
 
Applications of SMD resettable fuses: 1. plug-and-play protection on PC motherboards; 2. mobile phone battery and port protection; 3. game console port protection; 4. USB peripherals; 5. disk drives; 6. PDAs and digital cameras; 7. power supply ports; 8. general electronics. (Recommended reading: What resettable fuses solve in security and surveillance equipment)
 
 
We hope this short introduction has given you a clearer picture of SMD resettable fuses. If anything is still unclear, leave a message for us on the Contact Us page and we will answer it as soon as possible.

上一条:已经是第一条了!

下一条:自恢复保险丝为什么用高分子材料制作?