For engineers who are new to fuses, fuse selection is full of traps that easily lead to unnecessary design errors. This article walks through the mistakes we see most often.
1. Fuses cost too much. Many newcomers think a component that small should cost a few cents, so why pay tens of cents for it? Fuses really were expensive years ago, when the industry was young and neither quality nor volume could keep up, but today they cost far less than they used to. (Related reading: The history of fuse development)
Competition and economies of scale have brought fuse prices down markedly over the past few years. The real question is not what the component costs, but what it protects: inside a circuit protection scheme a fuse prevents catastrophic failure and keeps equipment and wiring safe. That is the value a designer has to weigh against the price.
2. A fuse does not do much, so it can be left out. Some designers gamble that a one-in-ten-thousand fault will never occur in their own product and see the fuse as a waste of time and effort. In fact the fuse guards against exactly that one-in-ten-thousand event, and it protects both the product and the people who use it.
Glass tubular fuse
3. During fuse selection, the rated current is often set at 1.5 times the rated operating current when the fuse is tested, which simplifies away the ripple current and the effect of temperature. Cumulative aging from switch-on pulses then leads to failures in the field.
4. When changing to a product from another brand, looking only at the current rating is not enough. Verify every parameter that selection depends on as well; in some cases the replacement has to offer different characteristics and a different current rating.
5. An abnormal open circuit on the production line is not necessarily a sign that the fuse is under-rated, so the rated current should not be raised on the spot. Doing so is likely to weaken the protection the fuse gives the circuit.