A varistor is a voltage-clamping protective device and a resistor with a non-linear voltage-current characteristic, used mainly to protect sensitive components. When the voltage in a circuit becomes excessive, the varistor clamps the voltage and absorbs the surplus current. Its full name is Voltage Dependent Resistor, abbreviated VDR, or simply varistor.
The resistive body of a varistor is a semiconductor, which makes it one type of semiconductor resistor. The zinc oxide (ZnO) varistors in widespread use today are built mainly from the elements zinc (Zn) and oxygen (O), so a zinc oxide varistor is a II-VI oxide semiconductor. In Taiwan they are called surge absorbers, and sometimes impulse (surge) suppressors. (Related reading: TVS Diode Characteristics and the Difference Between Unidirectional and Bidirectional TVS Diodes)
A varistor responds very quickly, typically in the nanosecond range: faster than a gas discharge tube, slightly slower than a TVS diode. When an overvoltage appears across its terminals, the varistor clamps the voltage to a relatively fixed level and thereby protects the circuit downstream. Its main parameters are varistor voltage, surge current capacity, junction capacitance and response time.
Junction capacitance is typically in the range of a few hundred to a few thousand pF, which in most cases makes a varistor unsuitable for direct use in the protection of high-frequency signal lines. In AC protection a large junction capacitance increases the leakage current, so this has to be considered carefully when designing the protection circuit.
The above covers the basics of the varistor. The working principle comes down to the following two points:
First: in a normally operating circuit, when the voltage applied to the varistor is below its threshold, the current through it is very small. The varistor then behaves like a resistor of infinite resistance, that is, like an open switch, and so protects the circuit.
Second: in a normally operating circuit, when the voltage applied to the varistor is above its threshold, the current through it rises sharply. The varistor then behaves like a resistor of almost zero resistance, that is, like a closed switch, and so protects the circuit.
That covers the essentials of the varistor. More related articles will follow, so keep an eye on our website. If you have any questions, leave a message for us on the Contact Us page and we will reply as soon as possible. (Recommended reading: 5KA SMD3216 SMD Gas Discharge Tube, JTS3216 Series)