深圳市集电通实业有限公司
电话 : 0755-8830-8258
邮编 : 518129
邮箱 : andyzheng@jdtfuse.com
网址 : http://www.joincircuit.com/
Application of Resettable Fuses in Tablet PCs
Tablet PCs are among today's most widely used personal digital devices: they handle most of the functions of a desktop computer, which explains their popularity. A tablet consists mainly of an internal power source (a lithium-ion battery), a main control board and an LCD display, and provides external ports for USB, SD cards and headphones.
Tablet PC architecture
How JDT Fuse devices are used in a tablet PC:
1) Where are they placed? A. JDT Fuse resettable fuses can be connected between the output of the tablet's lithium-ion battery and the power input of the main control circuit. B. JDT Fuse devices are also connected between the control circuit and the USB serial data interface. (Related reading: Overcurrent Protection with Resettable PPTC Fuses in a Noodle Making Machine)
2) What problem do they solve?
a) Resettable fuses are connected between the battery output and the power input of the control circuit. The main purpose is to protect the tablet against short circuits and overloads in the control circuit, and to prevent a short on the control board during assembly from damaging the lithium-ion battery circuit.
b) JDT Fuse devices are fitted on the 5 V supply line between the control circuit output and the USB port. They keep a short circuit on the USB load from burning out the tablet's control circuit, and also keep reverse injected current from damaging the internal circuits of the tablet.
3) How are they applied in practice? (Related knowledge: Overcurrent Protection with Resettable Fuses in a Humidifier)
a) Between the lithium-ion battery output and the power input of the control circuit, connect a resettable fuse in series, for example an ASMD1812-260/300, chosen according to the current; some tablets draw a little more power.
b) On the 5 V supply line between the control circuit output and the USB port, an ASMD1812-075/1210-075 in series is sufficient, again chosen according to the current.
The actual locations are shown in the figure below:

Tablet PC block diagram
4) Is there any other protection method? Before PTC devices came into wide use, one-shot current fuses were the most common solution; they were phased out because frequent replacement and maintenance pushed costs up. One-shot tubular fuses are still used today, but only the higher-current types, which rarely blow. Fuse resistors are another option, and this approach will also be phased out, with PPTC devices becoming the final choice. (Recommended reading: Key Application Points for Overcurrent Protection Devices in LED Lighting)