深圳市集电通实业有限公司

电话 : 0755-8830-8258

邮编 : 518129

邮箱 : andyzheng@jdtfuse.com

网址 : http://www.joincircuit.com/

How to Design a Chip Fuse

How to Design a Chip Fuse - in electronic products a chip fuse has two roles: it protects the end user from injury and protects the circuit from damage. These functions benefit the equipment user and the manufacturer alike. Over the past ten years, demand has risen sharply for electronic equipment serving information technology, mobile and consumer applications. With that rapid growth comes a greater risk of abnormal conditions in the equipment, so overcurrent protection devices such as chip fuses are required to avoid the risks of electrical overload and similar hazards.
 
 
Before analysing the electrical characteristics of the various chip fuses on the market, it is most important to understand the basic design principles behind each technology.
 
 
How to Design a Chip Fuse - a standard fuse may be based on a metal wire inside a sealed ceramic or glass tube filled with air or sand, whereas a chip fuse follows completely different principles. Most chip fuses look like standard chip components and are built on single- or multi-layer ceramic substrates. Some older designs used epoxy glass-fibre substrates similar to those of a printed circuit board (PCB). (Related reading: Why Instant Hot Water Taps Cannot Use Resettable Fuses)
 
Fuse
 
Chip fuse
 
 
The fuse element, deposited on a single-layer substrate or buried within a multi-layer substrate, is based on a highly conductive material such as copper, gold, or an alloy such as copper-tin (Cu-Sn) or silver-palladium. These composite materials improve the ability of the fuse to withstand surge currents, but their response to thermal stress is often less stable, which increases the likelihood of incorrect opening after a number of surge cycles.
 
 
How to Design a Chip Fuse - to obtain the required characteristics, the fuse element may be a laser-trimmed thick-film deposit or a chemically etched metal layer, depending on the substrate type. A welded gold wire may also be used. Because the shape and thickness are fixed, the element will open after a certain time under overload once the current reaches a given level.
 
 
To perform its function as the functional layer of the chip component, the fuse element must be isolated from environmental conditions. In a single-layer chip fuse the element is usually covered with a lacquer epoxy coating; in a multi-layer chip fuse the element is protected naturally by the substrate layers. Because chip fuses can operate at rated currents of up to 7-8 A, they require SMD connections with low impedance. (Recommended reading: Overcurrent Protection with Resettable Fuses)