深圳市集电通实业有限公司

电话 : 0755-8830-8258

邮编 : 518129

邮箱 : andyzheng@jdtfuse.com

网址 : http://www.joincircuit.com/

Common LED Power Supply Faults (Part 1)

Now that the Dragon Boat Festival holiday is over, we are back at work for a second day. Yesterday we received many questions about common faults in LED switching power supplies, so at the request of our customers we have put together a summary of them and share it here, in the hope that it helps junior engineers with design, development and repair work.
 
 
In the development and application of LED switching power supplies, engineers must not only make the designed product meet the relevant test standards, but also deal with the faults that appear while the product is in use. The common faults are a blown fuse, no DC output or unstable output voltage, and poor load capability of the supply. (Related article: Guangdong's LED Industry Enters a Virtuous Cycle as the Fuse Industry Gears Up)
 
 
Blown fuse: the most common fault in an operating LED switching power supply is a blown fuse. Generally speaking, when the fuse inside the supply blows, something is wrong with the circuit. Switching power supplies often work at high voltage and high current, so mains voltage fluctuations and surges can make the current inside the supply rise momentarily and blow the fuse.
 
LED lamp
 
LED
 
 
After a fuse blows, check in particular the rectifier diodes, the high-voltage filter electrolytic capacitors and the inverter power switch transistors at the input of the supply, and look for breakdown, open circuits or other damage. If the fuse really has blown, first inspect every component on the board for scorching or leaking electrolyte; if none of these signs is found, use a multimeter to check the switch transistor for breakdown or short circuit. (Recommended reading: Sluggish LED Market May Affect the Fuse Market (Part 1))
 
 
Note especially that you must never replace a faulty component and switch the supply on straight away. Other high-voltage components may still be faulty and can damage the new part, so the blown-fuse fault can only be cleared completely after every high-voltage component in that circuit has been checked and measured.
 
 
Therefore, the fuse plays an important part in an LED switching power supply. Only a suitable fuse lets the fuse serve longer, and neglecting this point at the selection stage is one of the reasons fuses blow so easily. That is all for today on common faults in switching power supplies; tomorrow we will continue with no DC output, unstable output voltage and poor load capability.

上一条:已经是第一条了!

下一条:自恢复保险丝为什么用高分子材料制作?