深圳市集电通实业有限公司

电话 : 0755-8830-8258

邮编 : 518129

邮箱 : andyzheng@jdtfuse.com

网址 : http://www.joincircuit.com/

Differences Between Switching Components and Voltage-Limiting Components in Surge Protection

Surge protection components are generally divided into three categories: switching components, voltage-limiting components, and overcurrent and overtemperature protection components. Many readers are unsure about the difference between switching components and voltage-limiting components, so this article explains it in detail.
 
 
First, their operating principles differ. In normal operation the switching component is open. When a lightning surge arrives, the switching component conducts and discharges the surge current to earth, protecting electronic equipment from surge damage. Switching components fall into three types: ceramic gas discharge tubes, glass discharge tubes (high-performance discharge tubes) and semiconductor overvoltage protectors (semiconductor discharge tubes and solid-state discharge tubes).
 
 
Voltage-limiting components include varistors and TVS diodes (transient voltage suppression diodes). Like Zener diodes, they have a voltage-clamping characteristic. When the applied voltage is below their conduction voltage, the internal resistance is very high and the leakage current is small; when the applied voltage exceeds the conduction voltage, the internal resistance drops sharply so that a large current can flow while the voltage across the device rises only slightly. Their conduction voltages are available in a range from low to high, which makes them convenient for circuits operating at different voltages. (Related reading: Common Faults in LED Switching Power Supplies (Part 1))
 
In addition, both have relatively high capacitance (low-capacitance TVS diodes are also available), so they are not suitable for high-frequency circuits.
 
 
Second, their role in surge protection also differs. A switching component is a gap-discharge device with a large lightning energy discharge capability; used in a line, its main function is to discharge lightning energy. A voltage-limiting component is a zinc oxide varistor device with a smaller lightning energy discharge capability but good overvoltage suppression; used in a line, its main function is to limit overvoltage.
 
 
Finally, they are applied differently. Switching components are mainly used for common-mode protection and are also often used for differential-mode protection in passive circuits. Voltage-limiting components are mainly used for differential-mode protection and are also commonly connected in series with switching components in common-mode circuits, so that the line is not shorted to ground once the switching component conducts; alternatively they serve as the current-limiting element for the switching component, interrupting follow current and allowing the switching component to reset.
 
 
The above summarizes the differences between switching components and voltage-limiting components in surge protection devices. If anything remains unclear, please leave us a message on the Contact Us page and we will reply as soon as possible. (Recommended reading: Innovative Circuit Protection Design for Automotive Electronics)