深圳市集电通实业有限公司

电话 : 0755-8830-8258

邮编 : 518129

邮箱 : andyzheng@jdtfuse.com

网址 : http://www.joincircuit.com/

Difference Between a Fusible Resistor and a Fuse

In an earlier article we looked at which is better, a fuse or a fusible resistor. Some readers are still only half clear about the difference between a fusible resistor and a fuse, so today the editor at Shenzhen Joincircuit Industrial Co., Ltd. will give a brief analysis.
 
 
A fusible resistor has a function similar to that of a fuse: it can cut off the current when the circuit is overloaded, and it can also act as a fuse, so many people confuse the two. But the load a resistor can carry is limited; once the current through it exceeds that limit the resistor is burnt out and presents an open circuit. That is not quite the same as the melting protection of a fuse.
 
 
A fuse has to perform three functions at the same time: protection, carrying and safety. A fusible resistor cannot perform any of the three well.
 
 
The protection function covers overload protection and short-circuit protection: when an impermissible overcurrent appears in the circuit, up to the extreme short-circuit current, the fuse must operate within the stipulated time and so protect the circuit or the component. The starting time, operating duration and other parameters of a fusible resistor can never be as accurately defined as those of a fuse; overload current protection cannot be guaranteed, and it does only a little against short-circuit current. (Related reading: Which fuse supplier in Shenzhen is best)
 
 
The carrying function of a fuse is assured by its melting energy value, which lets the fuse withstand a certain number of pulses of a given energy. This has to be calculated and assessed when the part is selected, whereas a fusible resistor has no comparable technical index: rated too small it is broken by the pulse, rated too large it offers no protection at all.
 
 
For the safety function, a fuse guarantees it through its rated voltage, breaking capacity and other indices, and above all through authoritative third-party safety certification. A fusible resistor is not a safety component and needs no safety certification, so its safety can well be imagined: protection is already inadequate, and while it is burning open there is no assurance that it will not create a hazard to its surroundings.
 
 
From the outline above we hope you now understand fusible resistors better. When a fuse is selected, choosing according to the actual conditions serves the protection of the product better. That is a brief explanation of the difference between a fusible resistor and a fuse. If anything else remains unclear, leave us a message on the Contact Us page and we will reply as soon as possible. (Recommended reading: Are Joincircuit fuses any good)