深圳市集电通实业有限公司

电话 : 0755-8830-8258

邮编 : 518129

邮箱 : andyzheng@jdtfuse.com

网址 : http://www.joincircuit.com/

Causes of Cracking in Time-Lag Fuses

In everyday use we occasionally meet a time-lag fuse failure that stops an appliance from working properly, and only after tracing the cause do we find that the fuse body has cracked. So what causes a time-lag fuse to crack? This article explains the reasons.
 
 
A time-lag fuse, as opposed to a fast-acting fuse, is generally one that opens when the current exceeds its rating for slightly longer than an ordinary fuse would tolerate. It carries surge and pulse currents well, does not open immediately, and clears only after a certain delay. (Related reading: Are time-lag fuses better than fast-acting fuses?)
 
 
Under what conditions does a time-lag fuse crack? Generally, the following situations apply:
 
 
1) The fuse has a poor contact at its crimp joint, which introduces contact resistance, so the fuse never reaches its rated overcurrent value; under a heavy load this generates heat and the fuse blows repeatedly.
 
 
2) Excessive load
 
 
3) Improper use
 
 
Time-lag fuses are mainly used in motors, power supplies and similar products, where a large inrush current flows at start-up. An ordinary fuse would open the instant the equipment is switched on; a time-lag fuse instead rides through the inrush current without opening, and that is what provides the protection. (Recommended reading: Common mistakes in fuse selection)
 
 
The above is a brief explanation of why time-lag fuses crack. If anything remains unclear, leave a message for us on the Contact Us page and we will reply as soon as possible.

上一条:已经是第一条了!

下一条:自恢复保险丝为什么用高分子材料制作?