Shenzhen JDT Fuse Industrial Co.,Ltd
Phone : 0755-8830-8258
Postcode : 518129
E-Mail : andyzheng@jdtfuse.com
URL : http://www.joincircuit.com/
Understanding the Maximum Operating Voltage of PPTC Resettable Fuses
Among the ratings of a PPTC resettable fuse is Vmax: the maximum voltage the fuse can withstand in its blocking, or tripped, state. In other words, when a resettable fuse is connected in series with a circuit and an abnormal current appears, the resettable fuse switches from a low-resistance to a high-resistance state within a defined time, limiting the abnormal current and protecting the downstream circuit from damage. At that moment the circuit voltage appears almost entirely across the resettable fuse. If this voltage exceeds Vmax, the fuse is easily damaged and can no longer return to its original state.
In long-term field use, this Vmax requirement is often overlooked.
For example, an engineer selecting a JDT Fuse PPTC for a 12 V circuit chose a device from the 16 V series. To verify its behaviour, a constant-voltage, constant-current power supply was connected and, with the load unchanged, the supply output voltage was slowly raised to increase the load current and find the minimum current at which protection would start. At the very moment the current reached that value, the PPTC was destroyed, and the power supply was reading 37 V.
What does this tell us? (Related reading: Packaging Technology for Resettable Fuses)
1.The part number was correct;
2.The test method was wrong — Vmax of the JDT Fuse PPTC was ignored;
The device failed because the engineer ignored the Vmax requirement and applied a voltage far above it. Raising the supply voltage while keeping the load resistance fixed is not a valid way to vary the load current.
The correct procedure is to set the supply to 12 V, connect the JDT Fuse PPTC in series with the circuit and vary the load so that the load current changes. When the current reaches the minimum value that trips the device, the resistance of the PPTC rises sharply from low to high, dropping the load current to around 10 mA and blocking the fault current.
Shenzhen Joincircuit Industrial Co., Ltd. therefore recommends the following method for testing a JDT Fuse PPTC with a constant-voltage, constant-current power supply:
1. Set the output voltage of the power supply to the required value;
2. Short the positive and negative output leads together;
3. Turn the current knob until the output current reaches the required value;
Resettable fuses are a comparatively recent type of overcurrent protection device and are now widely used in communications equipment, automotive electronics, general electronics, motor protection, toys and many other industries. (Recommended reading: How Resettable Fuses Work)