Resistors need little introduction, yet many people still have only a vague idea of what they are and how they are specified, so let us take you into the world of resistors.
Resistors come in many types and are usually divided into three groups: fixed resistors, variable resistors and special-purpose resistors. Fixed resistors are by far the most widely used in electronic products. They are further classified by material into many kinds; the common ones include RT carbon-film, RJ metal-film and RX wirewound resistors, together with the chip resistors that have become widespread in recent years.
Part numbers follow a clear pattern: R stands for resistor, T for carbon film, J for metal film and X for wirewound, taken from the first letter of each pinyin word. In older domestically made electronic products you often see resistors coated in green lacquer, which are the RT type; red ones are generally RJ, though green resistors predominate in old equipment. (Related reading: How a Fuse Works)
The once-rare 1/8 W colour-band carbon-film resistor is now among the most widely used parts in electronics projects, especially in miniature products where space is tight. Then there are chip resistors, a member of the surface-mount family. Once found mainly in imported miniature products, they are now available to hobbyists as well, some of whom use them to build wireless listening devices.
The volume potentiometer on an audio device is a variable resistor. Potentiometers are generally adjusted by hand, whereas variable resistors are usually small; the term variable resistor is also applied to potentiometers that are mounted on a board and rarely adjusted.
A variable resistor has three terminals. The resistance between two of them is fixed, and this value is called the resistance of the variable resistor. The resistance between the third terminal and either of the other two changes as the shaft is rotated, so the voltage or current in the circuit can be adjusted as required. (Related reading: Common Parameter Definitions for SMD Fuses)
The stronger the light, the lower the resistance. A photoresistor is a component whose resistance varies with the intensity, or brightness, of ambient light: the weaker the light, the higher the resistance. Its appearance and circuit symbol are shown in Figure 2.
Connect the two leads of a photoresistor to the probes of a multimeter and measure the resistance on the R1k range under different lighting: move the photoresistor from a dark drawer into sunlight or under a lamp and the meter reading will change. In complete darkness the resistance may exceed several megohms, so the meter reads infinity and the needle does not move, while in bright light it can fall to a few kilohms or even below 1 kOhm.