Shenzhen JDT Fuse Industrial Co.,Ltd

Phone : 0755-8830-8258

Postcode : 518129

E-Mail : andyzheng@jdtfuse.com

URL : http://www.joincircuit.com/

Construction of a Resistor-Type Fuse

A resistor-type fuse is named for its resistor-like appearance. On some products, colour bands are used to indicate the current rating, which is why they are also called PICO fuses. A resistor-type fuse is mainly made up of three parts: the fuse element, the electrodes and the support body. Here is a brief look at each of them.
 
 
Fuse element: the core of a resistor-type fuse, it interrupts the current when the fuse operates. Fuse elements of the same type and rating must be made of the same material, have the same dimensions, and keep the resistance as low and as uniform as possible; above all, their fusing characteristics must be consistent. (Related reading: 251 series resistor-type fast-acting fuses)
 
 
Electrodes: a resistor-type fuse normally has two of them. They connect the fuse element to the circuit, so they must offer good conductivity and must not introduce noticeable contact resistance at the mounting points.
 
 


 
Resistor-type fuse
 
Support body: the fuse element of a resistor-type fuse is usually thin and flexible. The body holds the element in place and turns the three parts into a fairly rigid whole, which makes installation and use easier. It must therefore have good mechanical strength, insulation, heat resistance and flame retardancy, and must not crack, deform, burn or short-circuit in service.
 
 
Fuses used in power circuits and high-power equipment are not limited to the three parts of an ordinary fuse; they also contain an arc-extinguishing device. The circuits they protect carry a high operating current, and the voltage present when the element melts is also high, so the element may melt or even vaporise while the current is still not interrupted. The reason is that, in the instant of fusing, the voltage and current draw an arc between the two electrodes. The arc-extinguishing device must have strong insulation, good thermal conductivity and electronegative properties. Quartz sand is the material commonly used for arc extinction.
 
 
That covers the construction of a resistor-type fuse. If anything is still unclear or you would like to know more, leave us a message and we will reply as soon as possible. (Recommended reading: 0603 SMD one-time fast-acting/time-lag fuses)