Shenzhen JDT Fuse Industrial Co.,Ltd

Phone : 0755-8830-8258

Postcode : 518129

E-Mail : andyzheng@jdtfuse.com

URL : http://www.joincircuit.com/

Why Fuses Blow: Main Causes and Factors

As is well known, a fuse blows because current flows through it and generates heat in the fuse element. If that heat cannot dissipate in time, the element keeps heating until it reaches its melting point, melts and opens the circuit, and the fuse has blown. The specific causes are mainly the following.
 
 
1. Overload. In household fuses this is the most frequent cause: the household load is too heavy, the fuse runs in overload and blows. It usually happens when air conditioners, electric heaters or other high-power appliances are running.
 
 
2. Poor contact. In a household circuit the fuse may be perfectly rated and the load modest, yet the circuit trips as soon as an air conditioner, electric heater, rice cooker or similar high-power appliance is switched on. The cause may be poor contact between the fuse and the terminal screw when the fuse was installed or replaced, which produces arcing and heat until the screw fixing the fuse in the porcelain plug or knife switch oxidizes and “seizes up”. (Related reading: How to Choose a Fuse Manufacturer)
 
 
3. Short circuit. If a fuse that has just been replaced blows the moment the switch is closed, a short circuit is the likely cause. Check the wiring first, then the load side: the plugs of kettles, rice cookers and portable appliances, as well as low-quality appliances, are all common sources of short-circuit faults.
 
 
4. Surges. When a circuit starts up or the supply is unstable, a momentary high current can easily open the fuse. A fuse element fitted with a loose screw, or one that has been damaged, will also blow.
 
 
These are the reasons why fuses blow. We hope the list above points you in the right direction. If you still have questions, leave a message on our contact page describing the problem, and we will reply as soon as possible. (Recommended reading: Correct Installation of Household Fuses and Points to Note)