Shenzhen JDT Fuse Industrial Co.,Ltd

Phone : 0755-8830-8258

Postcode : 518129

E-Mail : andyzheng@jdtfuse.com

URL : http://www.joincircuit.com/

How Polymer PTC Thermistors Work

The PTC effect describes a material whose resistance rises with temperature - the positive temperature coefficient effect. Most metallic materials show it. In such materials the PTC effect appears as a linear increase in resistance with temperature, which is what is usually called the linear PTC effect.
 
 
In a material that undergoes a phase transition, the non-linear PTC effect shows up as a steep rise in resistance - several orders of magnitude within a narrow temperature range. Quite a few types of conductive polymer behave this way, including polymer PTC thermistors. These conductive polymers are very useful for building overcurrent protection devices. (Related reading: How Polymer and Ceramic Thermistors Differ from Bimetallic Circuit Breakers)
 
 
Polymer PTC thermistors for overcurrent protection. Polymer PTC thermistors are also widely known as resettable fuses (referred to below simply as thermistors). Because of their distinctive positive temperature coefficient behaviour (the PTC characteristic), they are exceptionally well suited to overcurrent protection. A thermistor is used much like an ordinary fuse: it is connected in series with the circuit.
 
 
During normal operation the thermistor stays close to ambient temperature and its resistance is very low, so it does not impede current flow in the series circuit. When a fault produces an overcurrent, the greater power dissipation raises the thermistor's temperature; once it passes the switching temperature, resistance jumps sharply and the circuit current falls rapidly to a safe level. After the thermistor trips, the current in the circuit is greatly reduced. (Recommended reading: Operating Characteristics of Polymer Thermistors)
 
 
At a given ambient temperature, the trip time of a thermistor shortens sharply as current rises; at higher ambient temperatures a thermistor trips faster and has a lower holding current and tripping current. Recovery after tripping: because the resistance of a polymer PTC thermistor is recoverable, the device can be used again and again.
 
 
Resistance normally returns to about 1.6 times its initial value within ten to several tens of seconds, and by then the holding current is back at its rated value, so the device can be used again. Generally, thermistors with a smaller area and thickness recover relatively quickly, while larger thermistors recover more slowly.