Shenzhen JDT Fuse Industrial Co.,Ltd

Phone : 0755-8830-8258

Postcode : 518129

E-Mail : andyzheng@jdtfuse.com

URL : http://www.joincircuit.com/

How to Select a Fuse for an LED Driver

For low-power LED drivers, choosing the right fuse is an important step as well. In a circuit a fuse provides three basic protective functions: protection, current carrying and safety. Selection normally calls for attention to ten factors: rated current, rated voltage, operating temperature, voltage drop / cold resistance, melting characteristic, breaking capacity, melting integral, durability, construction, and safety approvals.
 
 
Broadly speaking, the right fuse should have a suitable melting characteristic and rated current, adequate and reasonable surge withstand capability, and a suitable breaking capacity, rated voltage and safety approvals, while the balance between protective performance and surge withstand capability has to be kept. (Related knowledge: The Protective Role of Fuses in Automotive Electronic Devices)
 
 
By melting behaviour, fuses are divided into fast-acting and time-lag types. Fast-acting fuses are usually used to protect resistive circuits or sensitive devices with little or no surge, while time-lag fuses are commonly used in switching power supplies, or in capacitive and inductive circuits that draw inrush current during hot plugging. The JDT Fuse 2410 series are hollow SMD fuses with a comparatively high surge withstand capability, and can be used to protect high-voltage circuits carrying large surge pulses.
 
LED bulb
 
LED bulb
 
 
Engineers today tend to choose a fuse with high surge withstand capability, that is, a high I2t value, yet neither a larger current rating nor a larger I2t is automatically better, and the choice cannot be made simply by picking a time-lag or a fast-acting type. It should be based on the actual I2t so that the fuse suits the application. (Recommended reading: Quality Control of Electronic Components for Aerospace Products)
 
 
Fuse selection must therefore cover not only current derating and the maximum ambient operating temperature, but also the current surge created when the supply is switched on; the larger of the calculated steady-state and transient currents is then taken.