As is widely known, resettable fuses are used in a very wide range of everyday applications, most often in the electronics industry. Ballasts, transformers, loudspeakers, batteries and chemical cells are the most common examples, and today we look at how they are used in each of these areas.
A ballast resistor is the device in a fluorescent lamp that limits current and generates a momentary high voltage, and it also provides the control that governs the strike. A fluorescent lamp needs a ballast to produce the high voltage and large current that strike the arc. When the lamp is switched on, the electronic ballast generates a high-voltage surge across the lamp terminals to strike it, and a self-oscillating circuit controlled by transistors is formed inside the ballast.
Many electronic ballasts fail because of the lamp. When the lamp is shorted, reaches end of life or is removed, an overcurrent condition appears and the lamp cathode goes open circuit. The load resistance falls because of the power factor. During starting the ballast works three or more times at abnormal current and high oscillation frequency, and the switching circuit produces an overcurrent that destroys the ballast. (Related reading: Detailed Explanation of Resettable Fuse Parameters)
A resettable fuse protects the lamp at end of life and also protects the transistors. Ballasts often fail because the upper and lower transistors switch on at the same time, so transistor fault protection is significant.
First, a resettable fuse resets by itself, which cuts rework and service calls and therefore reduces cost. Second, because it operates within a very short time it protects the more sensitive resistors in the circuit, so ballast reliability and service life improve. Third, its power consumption is very low: at normal operating current it does not overheat or waste energy. At normal current its resistance is very small, usually a fraction of an ohm, so no oscillation circuit forms. Fourth, its small size takes up little space on the board, which makes design easier.
A transformer is a device that changes AC voltage by electromagnetic induction. Power supplies built around a transformer usually fail through overcurrent, and the overcurrent is normally caused by a short circuit or a reduced load; the fault then makes the circuit smoke and catch fire, damaging the circuit and its connections.
Protection requirements for loudspeaker systems are strict. An ordinary fuse gives only one-time protection in a loudspeaker, which raises the return rate; an extra fuse holder and the wiring also add cost for the manufacturer. The fuse fitted must also match the specification, because a fuse of the wrong rating will damage the loudspeaker.
A circuit breaker is another solution, but it makes noise as it begins to break, before the contacts have fully opened. The best choice is therefore a resettable fuse. In the tripped state, where it shows high resistance, a resettable fuse behaves like a soft switch, and once the fault is cleared it returns automatically to a low-resistance path. (Recommended reading: Resettable Fuse Knowledge Q&A, Answers to Common Resettable Fuse Questions)