Resistors come up often among friends in the fuse industry, so in earlier articles we explained in detail what a resistor is and what it does. Today we will go through the precautions and measurement requirements for selecting resistors.
When buying any product there are points that deserve special attention, and resistors are no exception. A resistor must be checked before use: checking its performance means measuring whether the actual resistance matches the nominal value and whether the tolerance is within the permitted range. The method is to measure with the resistance range of a multimeter.
Next we will explain what to watch out for when measuring a resistor. Two points matter during measurement (Related reading: The function of a resistor)
1. Select the range according to the resistance being measured so that the pointer rests in the middle part of the scale, which makes reading easier.
2. After setting the resistance range, zero the meter: short the two probes together (let them touch directly) and adjust the “zero adjust” control until the pointer points exactly at “0” on the scale, then measure the resistance. Also make sure your hands do not touch either end of the resistor or the metal part of the probes, otherwise the reading will be inaccurate.
If the resistance measured with a multimeter is close to the nominal value, the resistor can be considered basically good; if it differs greatly or reads open circuit, it is faulty.
We hope this gives you a general picture. Be careful when selecting resistors: it is a matter of responsibility both for your product and for your own safety, and safety is particularly important for electrical products. That is all for today; if anything is unclear, leave a comment and we can discuss it together. (Recommended reading: Effect of packaging on the thermal characteristics of a resettable fuse)