A microwave oven, as its name suggests, cooks and heats food with microwaves. More and more households use one for cooking, and in winter it is used even more often because it is convenient. Occasionally, however, the fuse blows the moment the oven is switched on. This article explains how to clear that fault.
Inside a microwave oven the circuitry is divided into a power supply control system and a high-voltage control system. When a fault occurs, the high-voltage transformer serves as the dividing line: disconnect the secondary circuit first, and the faulty section can be identified quickly while the work stays safe. (Related reading: Fuse Blown on an LCD TV Power Board Mistaken for an “Explosion”)
First, remove the outer casing and locate the high-voltage transformer and the high-voltage capacitor. The secondary circuit is connected through a plug-in connector, so you only need to unplug it, which is very convenient. Fit a new fuse and power up again: one of the following two situations will appear.
Case 1: after power-up, the fan and the turntable run normally. This means the power supply control system and the transformer are sound and the fault lies in the high-voltage system. You can then check the high-voltage capacitor and the high-voltage rectifier stack. If the high-voltage capacitor is found to be broken down, the fuse blew because the short-circuit current in the transformer secondary was too large; replacing the capacitor with one of the same rating clears the fault.
Microwave oven
Case 2: after power-up the fuse blows again. This means the high-voltage circuit is normal and the fault lies in the transformer or in the power supply control circuit. To confirm, unplug the connector on the primary side of the transformer and power up again. One of the following will happen.
1. If the fan and the turntable run normally, the transformer is faulty, most likely an inter-turn short in a transformer winding, which is what burned out the fuse. Replacing the transformer clears the fault.
2. If the fuse inside the oven still blows, the fault is definitely in the power supply control system. Likely causes are a damaged interlock switch or monitor switch, or severe leakage or even a short in the power cord or wiring. These parts can be checked quickly; once the cause is found and the part repaired or replaced, the oven will work normally again.