Shenzhen JDT Fuse Industrial Co.,Ltd

Phone : 0755-8830-8258

Postcode : 518129

E-Mail : andyzheng@jdtfuse.com

URL : http://www.joincircuit.com/

How to Test the Performance of a Varistor

How do you test the performance of a varistor? Many readers have written in with this question, so today we have put together some notes on varistor testing in the hope that they will help.
 
 
Engineers at Shenzhen Joincircuit Industrial Co., Ltd. point out that, when selecting a varistor, the first thing an engineer should do is use a multimeter to check whether the component is intact and whether it can be used in the circuit. Testing varistor performance is in fact very simple: set the multimeter to the R×1kΩ or R×10kΩ range, then follow the normal procedure for resistance measurement to obtain the resistance of the varistor
 
 
Now reverse the test leads and measure again, recording the resistance. If both readings are infinite, the varistor is sound; if not, the element leaks badly and must not be used. (Related reading: Varistor (VDR) selection and points to note)
 
Varistor
 
PTC varistor
 
 
Testing the nominal working voltage of a varistor is another routine job. Here we take a varistor with a nominal voltage of 56 V as an example. Its test circuit is shown in Figure 1, in which the source is an adjustable DC supply of 0 to 60 V (higher than 60 V is also acceptable).
 
 
Increase the supply voltage gradually. At first the ammeter shows no reading; once the voltage reaches a certain value the reading rises sharply. The supply voltage at that point should be the nominal voltage of the varistor; if it is not, the varistor is performing poorly.
 
 
We hope this article has given you a general idea of how to test varistor performance. If anything is still unclear, please leave a message for us on the Contact Us page of our website and we will reply as soon as possible. (Recommended reading: What is a varistor and how does it work?)