Shenzhen JDT Fuse Industrial Co.,Ltd

Phone : 0755-8830-8258

Postcode : 518129

E-Mail : andyzheng@jdtfuse.com

URL : http://www.joincircuit.com/

Gas Discharge Tubes: Pros and Cons

Gas discharge tubes are commonly used as the first or the first two stages of a multi-stage protection circuit, discharging lightning transient overcurrents and limiting overvoltage. Their advantages are very high insulation resistance, very low parasitic capacitance and strong surge protection capability.
 
 
Gas discharge tubes come in SMD, two-electrode and three-electrode versions, with voltages from 75 V to 3500 V and more than one hundred variants, and are produced, monitored and managed strictly to the CITEL standard. They are commonly used as the first or first two stages of a multi-stage protection circuit, discharging lightning transient overcurrents and limiting overvoltage.
 
 
Advantages of gas discharge tubes: very high insulation resistance, very low parasitic capacitance and strong surge protection capability. (Related knowledge: Gas discharge tube selection guide)
 
 
Disadvantages of gas discharge tubes: the discharge delay (that is, the response time) is relatively long and the operating sensitivity is less than ideal; some types exhibit follow current, and prolonged follow current leads to failure; and a lightning surge with a steep wavefront is hard to suppress effectively.
 
 
When the tube starts to discharge it switches from an open circuit to a conducting state. During that transition the rate of change of the transient current, di/dt, is very large, and this rapidly changing transient current produces a transient electromagnetic
 
 
field that radiates energy in all directions, causing interference on nearby power and signal lines or inducing voltage in surrounding electrical circuits. The usual suppression methods are shielding, reduced coupling and filtering. (Recommended reading: How gas discharge tubes work and an analysis of their main parameters)
 
 
After the tube conducts, the incident wave is reflected back, which protects the electronic equipment behind it, but the electromagnetic field produced by the reflected wave current also radiates energy into the surroundings and must be suppressed.